Remote wireless trigger exposure h1,2,3

[Wick]

How is this done?
I want to fire my H2 remotely and wirelessy and have it wirelessly fire my Profoto flash packs,
I run pocket wizards (Plus) to fire my profoto flash packs wirelessly.
Now I want to fire the camera wirelessly as well.
???
Thanks!
Wick Beavers
wick@wickbeavers dot com

 

[Paul Claesson HUSA]

How is this done?
I want to fire my H2 remotely and wirelessy and have it wirelessly fire my Profoto flash packs,
I run pocket wizards (Plus) to fire my profoto flash packs wirelessly.
Now I want to fire the camera wirelessly as well.
???
Thanks!
Wick Beavers
wick@wickbeavers dot com

Wick, the information below is what I have in my notes.

Use the following cable, available from pocket wizard:
CM-E3-P
Pre-Trigger Remote Cable
US Catalog Number: 804-519

For remotely triggering the electronic shutter release of cameras with a Canon E3 or sub-miniphone (2.5 mm or 3/32", stereo or mono)
Remote Terminal.
Cable length: 3' (91.5 cm)
From 1/8" (3.5 mm) Mono Miniphone
Via Pre-Trigger Switch
To 3/32" (2.5 mm) Stereo Sub-Miniphone

This cable contains a Pre-Trigger Switch. When enabled, the camera behaves as if the camera's shutter release button were held half-pressed continuously. This makes the camera respond more quickly and consistently, but also consumes the camera's batteries much more quickly. When disabled, this cable functions identically to the CM-E3.
Compatible with cameras using Canon's E3 Remote Terminal or sub-miniphone connector including:

Hasselblad
H1
H1D
H2
H2D
H2D-39
H2F
H3D
H3DII

Here’s the link: http://www.pocketwizard.com/products/transmitter_receiver/40/CM-E3-P/overview/

Paul Claesson
Hasselblad USA